模锻
模锻 die forging / closed-die forging / impression die forging
开式模锻 closed-die forging / impression die forging
闭式模锻 no-flash die forging / flashless die forging
锤模锻 closed-die forging / impression die forging / drop forging / stamping
锻压机模锻 mechanical press forging
平锻 upsetting / heading
无飞边模锻 no-flash forging
无拔模斜度模锻 no-draft forging
模锻件 forging / workpiece
锻件重量 forging weight
普通锻件 conventional forging
（公差）锻件 close-tolerance forging
锻造工序卡 forging process chart
工序 operation / process / procedure
工步 process step
打击 blow / strike
锻件图 forging drawing
加工余量 machining allowance
镦锻、顶锻 upsetting / heading
镦粗 upsetting
压扁 flattening
去氧化皮 scale-breaking
拔长工步 drawing / elongating / fullering
拔夹钳头 tong-hold drawn / tagging
滚压工步 edging / edge rolling / gathering
弯曲工步 bending
制坯工步 pre-forming
平锻聚料 gathering / pushing up / upsetting
锥形镦粗 taper upsetting / coning
粗（初）锻 blocker-type forging
预锻 pre-forging / blocking
终锻 finish-forging
返回锻模校正 re-striking
分模线 parting line
模锻斜度、拔模角、拔模斜度 draft angle
外拔模角 outside draft
内拔模角 inside draft
自然拔模角 natural draft
相配拔模角 matching draft
外圆角 corner
内圆角 fillet
未注明圆角 all radii not specified
尺寸按交点注 all dimensions specified form intersections
模锻方案 forging form
一料多件 multi-forging on one billet (bar)
一模两件 two at a time
一模多件 multi at a time
调头锻 turn-end forging
一火多件 multi-forging in one heat
打零件号、炉号码及模具号处 raise part No. heat code and die No. here
除注明处外 unless otherwise noted
